Voco Easy Glaze Bottle 5ml

Surface Sealant For GIC
Brand : Voco
  Free shipping available on order of 2200 and above.
  7 Days Return Policy.
  100% Genuine Products.

  Check COD Availability

3% OFF
Rs. 4,850 Rs. 4,700
Voco Easy Glaze Bottle 5ml Voco Easy Glaze Bottle 5ml Voco Easy Glaze Bottle 5ml Voco Easy Glaze Bottle 5ml Voco Easy Glaze Bottle 5ml Voco Easy Glaze Bottle 5ml Voco Easy Glaze Bottle 5ml

INDICATIONS

  • Surface sealing of glass ionomer cements, provisional crowns and bridges and definitive composite restorations.
  • Protecting glass ionomer cement surfaces against the effects of moisture and dehydration immediately after placement.
  • Sealing glass ionomer cement liners/build-up restorations before taking impressions.
  • Sealing and protecting adhesive interfaces between restoration and tooth structure.

PRECAUTIONS 

  • Do not use in combination with materials containing eugenol as they can impair the polymerisation or adhesion of Easy Glaze.
  • Easy Glaze is volatile. Only use in well-ventilated areas. Keep bottle out of direct sunlight.
  • Easy Glaze is flammable. Do not use near open flames or ignition sources.
  • Easy Glaze contains multifunctional acrylates, methyl methacrylate and BHT. Easy Glaze should not be used in case of known hypersensitivities (allergies) to any of these ingredients. - In case of contact with the eyes, immediately rinse with water and seek medical advice. - In case of contact with skin or oral mucosa, immediately remove the material with a cotton pad. Thoroughly rinse affected areas with water afterwards.

DIRECTION TO USE

  • Ensure that the surfaces to be treated are dry.
  • Dispense a few drops of Easy Glaze into a disposable dish. Replace bottle cap immediately after use.
  • Apply material within 1 min. to guarantee that an oxygen inhibition layer does not form.
  • Apply a thin and air bubble-free layer of the material onto the relevant surfaces with the enclosed brush.
  • Light-cure all treated surfaces with a visible light (> 500 mW/cm2, halogen or LED) for 30 s immediately after application. Hold the light source as close as possible to the surfaces being polymerised. Repeat light-curing if the surfaces appear tacky or yellow.
  • Repeat steps 2 - 5 if a second layer appears to be necessary.
  • Where appropriate, check occlusion.
  • 1 x 5ml Bottle
Voco Easy Glaze Bottle 5ml
You have successfully subscribed!